Specifications

Commands in an SP201-SA Session 7-5
SP201-SA™ Customization and Maintenance Guide
show hardware Displays the hardware configuration. See
Section 7.2.4.13, The show hardware Command.
show states Displays the current states for all trunks and
timeslots. See Section 7.2.4.14, The show states
Command.
show stats Displays the reset statistics. See Section 7.2.4.15,
The show stats Command.
show template Displays the IAM & ACM template numbers
configured for all channels. See Section 7.2.4.16,
The show template Command.
show time Displays the SP201-SA’s system time. See
Section 7.2.4.17, The show time Command.
show trace Displays a list of channels on the SP201-SA,
indicating those that have tracechan enabled. See
Section 7.2.4.18, The show trace Command.
show trunks Displays trunk framing, protocol, and SS7
signaling link information. See Section 7.2.4.19,
The show trunks Command.
show version Displays the SP201-SA software product’s
application version. See Section 7.2.4.20, The
show version Command.
trace (before SignalPath
software version 1070)
No Longer Available. See Section 7.2.5.2,
The trace isup Command.
trace (in SignalPath
software version 1070
and later)
Starts automated trace functions or stops all
trace functions. See Section 7.2.5.5, The trace
Command.
trace cas Displays signaling on Timeslots between CAS
and peer protocol. See Section 7.2.5.1, The trace
cas Command.
tracechan
No Longer Available. See Section 7.2.5.1,
The trace cas Command.
trace isdnmsg Enables ISDN raw message traces. See
Section 7.2.5.3, The trace isdnmsg Command.
Table 7-1. Maintenance and Troubleshooting Commands for
the SP201-SA
(3 of 4)
Command Description
!
!