Specifications

7-44 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
• If the card has software for ANSI SS7 to ITU C7 (or a variant), a
prompt asks which side (ANSI or ITU) to configure.
2 Do one of the following:
a If you do not wish to enter a point code, press Enter without typing
anything.
Note: We recommend the default (that is, not typing a point code),
so that the trace will accept transmissions from all point codes.
If you want to use a point code, the system will filter transmissions
to accept messages only from the point code you enter.
 The following prompt is displayed. Go to Step 4.
b If you wish to enter a point code for ANSI SS7 connections, type
ansi and press Enter.
c If you wish to enter a point code for ITU C7 connections, type itu
and press Enter.
 If you typed ansi or itu, the following prompt is displayed:
Point Code :
Enter 'ansi' or 'itu' if point code to be used :
CIC :