Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-43
SP201-SA™ Customization and Maintenance Guide
c Type trace off and press Enter.
 All traces are stopped.
7.2.5.2 The trace isup Command
The trace isup command, available for SS7 protocols, allows you to trace all
or specified details of ANSI SS7 or ITU C7 messages. The trace isup
command replaces the former trace command. (To use the new trace
command, see Section 7.2.5.5, The trace Command.)
You can specify this trace. In CAS-to-SS7 signaling or SS7-to-SS7 signaling,
this is also an automated trace function. (To use automated trace functions,
see Section 7.2.5.5, The trace Command.)
Note: If you wish to trace more than one detail but not all details, you must
enter the trace isup command once for each detail.
How to Enable the trace isup Command
1 To trace an SS7 message type, type trace isup on at the user>
prompt, and press Enter.
 The trace starts. One of the following messages is displayed.
• If the card’s SS7 software is only for ANSI SS7 or only for ITU C7
(or a variant), the following prompt is displayed. Go to Step 3.
trace cas off
All channel traces are now off
[2130/08/25 18:57:47]: Command "trace cas off" completed
user> trace off
[2129/01/06 23:05:25]: Command "trace off" completed
user>