Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-41
SP201-SA™ Customization and Maintenance Guide
Caution: You can enable trace cas for more than one timeslot,
as shown in the following list of formats for the trace cas
command; however, this is not advised because of the
possibility of losing calls.
If you enable trace cas for more than one timeslot, a warning is
displayed.
Then, if you answer y, the trace is enabled.
Information will be displayed, similar to that shown below.
Note: If you enable trace cas for more than one timeslot, and later
wish to stop the trace, type trace cas off and press Enter.
usage: trace cas [trk:ts] [on/off]
or trace cas [trk:ts] [trk:ts] [on/off]
or trace cas [trk] [on/off]
or trace cas all [on/off]
user> trace cas all on
************************************************************
* WARNING!!! Multi-channel tracing is NOT intended for *
* operational use! Its use in high traffic *
* may cause improper operation and may even *
* cause a program reset. *
************************************************************
Do you wish to continue (y/N) : y
Traces enabled
[2130/08/25 18:57:02]: Command "trace cas all on" completed
15586.1100-slot4-user>
!