Specifications

7-4 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
show x Shows specified information as described below.
Type show help for a list of show commands.
show alarms Displays information about the SP201-SA’s
trunk alarms. See Section 7.2.4.1, The show alarms
Command.
show almrelay Shows trunk alarm propagation. See
Section 7.2.4.2, The show almrelay Command.
show ani Displays the ANI substitution table. See
Section 7.2.4.3, Viewing the ANI Table.
Note: This command is available only if the optional
ANI feature is included in the software.
show banner Displays the application banner, listing
information about the SP201-SA. See
Section 7.2.4.4, The show banner Command.
show buffers Displays the size of message buffer pools. See
Section 7.2.4.5, The show buffers Command.
show ccstates Displays each ISDN channel’s SS7–ISDN Call
Control state and last event. See Section 7.2.4.6,
The show ccstates Command.
show clocks Displays clocking information. See
Section 7.2.4.7, The show clocks Command.
show connections Displays CIC/timeslot/peer timeslot
relationships. See Section 7.2.4.8, The show
connections Command.
show dchans Displays signaling information for ISDN trunks.
See Section 7.2.4.9, The show dchans Command.
show events Displays a list of the events and states for each
protocol. See Section 7.2.4.10, The show events
Command.
show fgd Displays the information digits translation table
for Feature Group D. See Section 7.2.4.11, The
show fgd Command.
show framers Displays the configuration and status of the
trunks on the Line Interface Module (LIM). See
Section 7.2.4.12, The show framers Command.
Table 7-1. Maintenance and Troubleshooting Commands for
the SP201-SA
(2 of 4)
Command Description