Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-39
SP201-SA™ Customization and Maintenance Guide
Note: The show trace command indicates the traces that are enabled. See
Section 7.2.4.18, The show trace Command.
7.2.5.1 The trace cas Command
The trace cas command, available for CAS protocols, is used to display
detailed information about interworking messages sent between protocols.
You can trace one or more timeslots, up to all timeslots on the SP201-SA.
The trace cas command replaces the former tracechan command.
You can specify this trace; it is also an automated trace function. (To use
automated trace functions, see Section 7.2.5.5, The trace Command.)
How to Enable the trace cas Command
Caution: Do not use the trace cas command for more than one channel
on a card when the card is passing a large volume of traffic; otherwise,
you may lose calls.
1 If you want to turn tracechan on, type trace cas m : n on at the
user> prompt, and press Enter,
where m represents the trunk and n represents the timeslot you want
to trace.
 While the trace for a single timeslot is on, information similar to
the following is displayed. (Information is displayed in a different
format for more than one timeslot.)
!