Specifications

7-36 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
7.2.5 Traces
Traces are diagnostic commands; they are used only for debugging
purposes. Each type of trace monitors a specific part of transmissions. In
most cases, trace information should be collected and sent to Technical
Services at Encore Networks, Inc., for analysis and problem detection.
Caution: Traces are disruptive; they affect system performance. They
consume resources, slowing processing speed. Run a trace only to help
analyze problems.
You can run more than one trace simultaneously. However, running
multiple traces may cause the SP201-SA to reset.
Use of traces is not meant for a live network. Contact Technical Services
before you use a trace command.
In SignalPath software version 1070, the trace commands changed from
those of previous software versions. The former trace commands are not
available in version 1070 and later. Table 7-4 lists the mapping of former
trace commands (before software version 1070) to new trace commands
(version 1070 and later).
user> show version
*************************************************************
************** APPLICATION VERSION INFORMATION **************
*************************************************************
Application: DTMF/ITU Q.767 C7 Standalone
Application Part Number: 14752.0705
Package Part Number: 15141.0705
Release Date: 10/18/01 20:45:15
*************************************************************
user>
!