Specifications

7-32 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
 If the SP201-SA’s time has not been set previously, the following
message appears.
 In any case, then the following information is displayed:
7.2.4.18 The show trace Command
This command displays the status of the traces on the SP201-SA, indicating
the traces that are enabled on each channel.
Note: To enable or disable traces, see Section 7.2.5, Traces.
How to Use the show trace Command
1 At the user> prompt, type show trace and press Enter.
 A list of debug traces is displayed, indicating their statuses.
Note: The traces listed depend on the software on the SP201-SA.
• If there is only one trace available on the SP201-SA, the listing may
be short (depending on the trace itself), as shown in the following
example.
Warning! System date/time has not been set!
user> show time
******************************************************************************
****************************** SYSTEM DATE/TIME ******************************
******************************************************************************
System Date and Time = Sat 2000/01/01 00:03:36.354
******************************************************************************
user>