Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-31
SP201-SA™ Customization and Maintenance Guide
7.2.4.16 The show template Command
The show template command indicates which IAM template and ACM
template are being used on each channel of the DTMF, R1, R2, or N5 trunks.
How to Use the show template Command
1 At the user> prompt, type show template and press Enter.
 The system displays the numbers of the IAM templates and ACM
templates used on each CAS channel, similar to the following:
Note: Each CAS channel can use one of five templates for IAM and
one of five template for ACM. Usage of IAM and ACM templates is
assigned in the procedures in Section 3.3.2.1, The config dt Command;
Section 3.3.3.1, The config r1 Command; Section 3.3.4.1, The config r2
Command; and Section 3.3.5.1, The config n5 command.
7.2.4.17 The show time Command
The show time command displays the SP201-SA’s current system time. (If
you wish to set the system time, see Section 2.3.1, The config time Command.)
How to Use the show time Command
1 At the user> prompt, type show time and press Enter.
user> show template
Template (IAM No.-ACM No.)
Trunk/ts 1 2 3 4 5 6 7 8
1/1 1-1 1-1 1-1 1-1 1-1 1-1 1-1 1-1
1/9 1-1 1-1 1-1 1-1 1-1 1-1 1-1 1-1
1/17 1-1 1-1 1-1 1-1 1-1 1-1 1-1
1/25
2/1 1-1 1-1 1-1 1-1 1-1 1-1 1-1 1-1
2/9 1-1 1-1 1-1 1-1 1-1 1-1 1-1 1-1
2/17 1-1 1-1 1-1 1-1 1-1 1-1 1-1
2/25
user>