Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-29
SP201-SA™ Customization and Maintenance Guide
7.2.4.14 The show states Command
You use the show states command to display a list of current states for
timeslots on the trunks, whether in service or out of service.
Note: This command is intended for use by Technical Support personnel
when customers report troubleshooting problems.
How to Use the show states Command
1 At the user> prompt, type show states and press Enter.
 The list of current states, similar to the following, is displayed.
Note: In the display for the show states command, channels that are
out of service display blanks. In addition, T1 trunks show timeslots
25 through 31 as blank because T1 trunks have only 24 channels. E1
trunks show timeslot 16 as blank because timeslot 16 is used for
signaling.
user> show states
States (S7state-DTstate)
Trunk/ts 1 2 3 4 5 6 7 8
1/1 3-3 3-3 3-3 3-3 3-3 3-3 3-3 3-3
1/9 3-3 3-3 3-3 3-3 3-3 3-3 3-3
1/17 3-3 3-3 3-3 3-3 3-3 3-3 3-3 3-3
1/25 3-3 3-3 3-3 3-3 3-3 3-3 3-3
2/1 3-3 3-3 3-3 3-3 3-3 3-3 3-3 3-3
2/9 3-3 3-3 3-3 3-3 3-3 3-3 3-3
2/17 3-3 3-3 3-3 3-3 3-3 3-3 3-3 3-3
2/25 3-3 3-3 3-3 3-3 3-3 3-3 3-3
user>