Specifications
7-28 Chapter 7: Maintenance and Troubleshooting
SP201-SAâ„¢ Customization and Maintenance Guide
7.2.4.13 The show hardware Command
The show hardware command lists the hardware specifications for the
SP201-SA. The command shows the device and its trunk configuration.
How to Use the show hardware Command
1 At the user> prompt, type show hardware and press Enter.
î‚™ A display similar to the following appears.
Haul Type The general line length that the software
configuration reflects. The default is Short, for a
cable 0 to 133 feet (0 to 41 meters) long.
Line Length Indicates the length of the T1 cable. (This
parameter is not applicable for E1 lines.)
Trunk State Indicates the trunk state. Initialized means that
the trunk is fully operational.
LIM type Indicates the type of LIM installed. The first entry
describes trunks 1–4; the second entry describes
trunks 5–8.
user> show hardware
******************************************************************************
*************************** HARDWARE CONFIGURATION ***************************
******************************************************************************
Platform: SP201-SA
Configuration: 4 Trunks/0 Receive DSPs/1 QUICC
LIM Type: 2 T1 100 Ohm/2 T1 100 Ohm
******************************************************************************
user>
Table 7-3. Parameter Descriptions for the show framers Command (2 of 2)
Parameter Description