Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-27
SP201-SA™ Customization and Maintenance Guide
7.2.4.12 The show framers Command
You use the show framers command to view detailed information about the
SP201-SA trunks.
How to Use the show framers Command
1 At the user> prompt, type show framers and press Enter.
 Information similar to the following is displayed.
Table 7-3 describes the parameters displayed when you execute the show
framers command.
user> show framers
******************************************************************************
**************************** FRAMER CONFIGURATION ****************************
******************************************************************************
Trunk Line Line Framing Haul Line Trunk
Trunk Type Impedance Coding Type Type Length State
******************************************************************************
1 E1 120 Ohms HDB3 CAS-CRC Short N/A Initialized
2 E1 120 Ohms HDB3 CAS-CRC Short N/A Initialized
3 E1 120 Ohms HDB3 CCS Short N/A Initialized
4 E1 120 Ohms HDB3 CCS Short N/A Initialized
******************************************************************************
LIM type: 2 E1 120 Ohm/2 E1 120 Ohm
******************************************************************************
user>
Table 7-3. Parameter Descriptions for the show framers Command (1 of 2)
Parameter Description
Trunk Lists the trunk numbers (1–8).
Trunk Type Indicates whether the connection is T1 or E1.
Line Impedance Indicates the impedance (100 ohms for T1 lines;
75 ohms or 120 ohms for E1 lines).
Line Coding Indicates the types of T1 and E1 coding used on
the trunk (i.e., AMI or B8ZS for T1 and AMI or
HDB3 for E1.
Framing Type Indicates the type of trunk framing selected (e.g.,
D4 SF for T1 or 704 for E1).