Specifications

7-2 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
Caution: The SP201-SA is not designed to be serviced in the field. If
the SP201-SA malfunctions and you are unable to isolate the problem,
contact Encore Networks as indicated above. Do not remove the cover
or disassemble the SP201-SA, as doing so may void its warranty.
7.1 Commands in an SP201-SA Session
To execute commands for the SP201-SA, you first need to establish a session
between the SP201-SA and a user-supplied control console, as described in
Section 1.5, Connecting to the Control Console. After you establish this session,
you will use a command line interface to execute the operational commands
listed in Table 7-1.
Table 7-1 lists monitoring commands. The configuration commands are
discussed in the configuration chapters.
Note: In all commands, make sure you type the port number or trunk
number that corresponds to the port you are configuring, regardless of the
port or trunk number shown in the instructions.
For details of SP201-SA port numbering, see the Note in Section 1.3,
Connecting the SP201-SA to the Telephony Network.
!