Specifications

7-18 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
7.2.4.3 Viewing the ANI Table
Note: The commands for configuring and viewing Alternate Number
Insertion (ANI) are available only if the optional ANI Feature has been
installed.
The show ani command lets you see the ANIs in the ANI substitution table.
The following procedure provides guidelines.
Note: To configure numbers in the ANI table, see Section 5.3.1, Configuring
ANI Substitution.
How to Use the show ani Command
1 At the user> prompt, type show ani and press Enter.
 The console displays the contents of the ANI substitution table,
one page at a time. If you have reached the end of the ANI table, the
user> prompt follows the table. The display is similar to the
following.
Note: The table is listed in four columns. Each column holds a pair
of numbers. Within each pair, the number on the left identifies the
table position, and the number on the right is the ANI.