Specifications

7-14 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
b If you do not wish to reset the statistics, type n and press Enter.
 The statistics remain at their current values. The following
prompt appears, followed by the user> prompt.
7.2.3.3 The reset systimer Command
The reset systimer command resets the relative clock time to 0 (zero). To use
the command, type reset systimer and press Enter. The system clock
resets to zero, and the following message is displayed.
7.2.4 The show Commands
You use the show commands to display current, snapshot information about
the SP201-SA’s hardware configuration. The show commands use the format
show x, where x can be any of several variables, discussed in the sections
below.
To see a list of show commands, type show and press Enter. The console
will display a list of show commands available in the SP201-SA software,
similar to the following.
statistics NOT reset
user>
System relative time clock reset to 0