Specifications

Monitoring and Troubleshooting the SP201-SA Software 7-11
SP201-SA™ Customization and Maintenance Guide
7.2.3 The reset Commands
To see a list of reset commands, type reset and press Enter. The console
will display a list of reset commands available in the SP201-SA software,
similar to the following.
7.2.3.1 The reset chan Command
You can perform a reset at the channel level. You use the reset chan command
to reset a designated channel or multiple channels.
Note: The reset chan command is not used to implement configuration
changes. Use the reset chan command only for cases in which the channel is
not responding properly.
How to Use the reset chan Command
Caution: The reset chan command causes all calls on the specified
channels to be dropped. In addition, the specified channels will drop
any loopbacks and any disable statuses.
If a specified channel range intersects but does not encompass a
disabled span, the reset chan command will be rejected, and no channels
will be reset.
1 At the user> prompt, do one of the following:
user> reset
******************************************************************************
***************************** RESET COMMAND HELP *****************************
******************************************************************************
chan - Reset CAS channel(s) [trunk/timeslot(s)] back to their initial state
stats - Reset card statistics
systimer - Reset the relative time clock back to 0
******************************************************************************
user>
!