Specifications

7-10 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
of commands recently used. (Note that the last command shown is always
history, because you have just entered that command.)
7.2.2 The config Commands
To see a list of config x commands, type config or config help and
press Enter. The console will display a list of the config commands available
in the SP201-SA software, similar to the following.
Most config commands are used only when configuring the SP201-SA. See
the appropriate chapters for the protocols you are configuring.
user> history
******************************************************************************
**************************** COMMAND HISTORY LIST ****************************
******************************************************************************
035: assign cics
036: config timeslots
037: config cics
038: config connections
039: reset
040: reset chan
041: reset stats
042: reset systimer
043: dumpchan
044: show connection
045: show connections
046: show almrelay
047: reset
048: reset systimer
049: history
******************************************************************************
user>
user> config
*** CONFIG COMMAND HELP ***
alarms - Enable/Disable reporting of alarms on a trunk (span)
Warning: Interrupts traffic if a live trunk is disabled
cics - Modify the CIC connectivity
clocks - Select a clock source for framing
connections - Configure timeslot and CIC mapping - Auto & manual modes
dt - Configure the channel parameters for the selected
channel(s)
framer - Configure the framer parameters for a trunk (span)
logging - Enable or disable display of logging messages
sp200 - Configure several card level options