User guide

9-22
Using the Old Command Line Interface (CLI)
Task init_ports
Task reset_sequence
Scope break at time 1250 breakpoint #2 break in
memsys_test_top.vshell.check_all
cli_5 >.
Task check_all:
THE RAND MEM0 ADD IS 00001011
mem_add0[00001011] is 00001011
CPU 0 requests bus on arb0
THE RAND MEM1 ADD IS 10010111
mem_add1[10010111] is 10010111
CPU 0 writeOp: address 0b data df
CPU0 is writing
WRITE address = 00b, data = 0df
CPU 0 releases bus on arb0
CPU 0 requests bus on arb0
CPU 0 readOp: address 0b data df
READ address = 00b, data = 0df
CPU 0 releases bus on arb0
CPU 0 Delay cycle value: 1
CPU 1 requests bus on arb1
delay = 1
THE RAND MEM0 ADD IS 10110001
mem_add0[10110001] is 10110001
CPU 1 writeOp: address 97 data f1
CPU1 is writing
WRITE address = 097, data = 0f1
CPU 1 releases bus on arb1
CPU 1 requests bus on arb1