User guide

9-17

Using the Old Command Line Interface (CLI)

Use the following command line to run the simulation with debug:

% simv -s

The following is the output while using the CLI:

Contains Synopsys proprietary information.

Compiler version 7.1_Beta2; Runtime version 7.1_Beta2; Oct

16 16:55 2003

$stop at time 0

cli_0 > break in memsys_test

set break #1 in memsys_test

cli_1 > break in check_all

set break #2 in check_all

cli_2 > break at memsys1.vr69:

set break #3 at memsys1.vr:69

cli_3 > cont

Constructing new CPU.

WARNING: Ignoring seed value 0. Seeding with value 1. Seed

must be greater than 0.

Constructing new CPU.

Scope break at time 0 breakpoint #1 break in

memsys_test_top.vshell.memsys_test

cli_4 >.

Task init_ports

Task reset_sequence

Scope break at time 1250 breakpoint #2 break in

memsys_test_top.vshell.check_all

cli_5 > .

Task check_all:

CPU 0 requests bus on arb0

CPU 0 writeOp: address 0b data df

CPU0 is writing

WRITE address = 00b, data = 0df