User guide

2-1
Starting VirSim
2
Starting VirSim 1
This chapter describes procedures required to start and run VirSim.
There are two ways to start VirSim: entering multiple command line
options that specify all the files that you need, or entering only the
required options and using the interface to specify the remaining files.
The following information is covered in this section:
• VCS VirSim GUI Startup Procedures
• Scirocco VirSim GUI Startup Procedures
• Standalone VirSim GUI Startup Procedures
• Opening and Closing History Files
• Saving and Loading a Configuration File
• Loading Sources