User guide

8-9
Interactive Window
Controlling the Simulator
This section describes several ways to start and control the simulator.
The simulator runs forward until it is stopped (using the Stop icon or
Ctrl+C), finishes, or a breakpoint is reached. You can set breakpoints
from the Interactive Window or any other window linked to the SIM
link group.
To go backwards in a window, that window first must be unlinked from
SIM.
The following information and procedures are covered in this section:
• Summary of Simulator Control Commands
• Breakpoint Durations
• Expression Breakpoints
• Control Simulation from the Waveform Window
• Control Simulation from the Source Window
• Control Simulation from the Logic Browser
• Control Simulation from the Register Window