Service manual

98 Encore — Installation and Service Manual
Section 3 — Maintenance and Troubleshooting
The Thomson Grass Valley NetCentral SNMP Manager automatically reg-
isters itself with the Encore System Controller to receive the Traps. Third
Party SNMP Managers need to manually register with the Encore System
Controller.
Third Party SNMP Managers
Other industry standard Third Party SNMP Managers can monitor Encore
System Controllers. For their installation & configuration, please contact
your SNMP Manager Software vendor. The Third Party SNMP Manager
needs to be manually registered in the Encore SNMP agent database so the
Encore System Controller will send Traps to the corresponding SNMP
Manager.
Note Customers using a Third Party SNMP Manager should contact Grass Valley
Customer Service for instructions on obtaining MIBs.
The Third Party SNMP Manager requires the following MIBs:
• GVG-ELEMENT-MIB
• GVG-REG-MIB
• THOMSON-MATRIX-MIB
• GVG-ENCORE-SCB-MIB.mi2
Add all the MIB files to the MIB repository of the SNMP Manager you use.
Register a New SNMP Manager
In the GVG-ELEMENT-MIB, a Trap target table is defined to store the IP
Addresses and community names of the SNMP Managers intended to
receive Traps from the Encore System Controller SNMP agent.
Add a New SNMP Manager
From the Third Party SNMP Manager perform the following steps:
1. Send a GET request for:
gvgTtCfgTableNextIndex variable defined in GVG-ELEMENT-MIB.
For this example we will use 2 as the response for the GET request.