Service manual

90 Encore — Installation and Service Manual
Section 3 — Maintenance and Troubleshooting
4. Run the mkdosfs executable by typing
c:\> mkdosfs -w <Drive label of Compact Flash reader>:
Note Be sure to use the -w option and use care when selecting the drive name.
5. Copy the entire contents of c:\Program Files\Grass Valley
Group\Encore\FileSystem\
folder to the Compact Flash (two
files).
6. Copy all the files and folders from the c:\Program Files\Grass
Valley Group\Encore\Encore Image\
folder except the
Encore.tar file to the Compact Flash (16 items).
Note Be sure there are no Read Only options set for the copied files.
Flash Memory Format Procedure (Using Only Encore Software CD)
If you wish to use a PC that has not had Encore software installed, you can
use the Encore Software CD to format Compact Flash cards.
•The mkdosfs.exe file is located at the same location:
<Drive label of CD drive> \ Unsupported.
The files copied in steps Step 5 and Step 6 above are included on the Encore
Software CD at the following locations:
• <Drive label of CD drive> \ FileSystem (2 files)
• <Drive label of CD drive> \ Encore Image (16 items, do not copy the
Encore.tar file).
Incorrectly Named Salvo Recovery
When new Salvos are created, the new Salvo is displayed in LRP with a
Keycap name <filename> that must be the same as the Salvo file name
<filename>. If this is not done, problems can occur that require the special
recovery procedures described below.
Salvo Filename Different from Keycap Name
Scenario
Salvo is created from an existing Salvo using LRP, wherein the Keycap
name is duplicate.