Service manual

84 Encore — Installation and Service Manual
Section 3 — Maintenance and Troubleshooting
;NPBlock is used to control the Router operations by re-
dundant serial client. To block operations from subor-
dinate write 'Enable', else write 'Disable'.
NPBlock=Disable
;NetDelay is used to configure the periodicity of the
Network connectivity detection for connected NP/RCL cli
-
ents, in seconds. Default is 5 seconds, can be config-
ured between 3 to 255, 0 shall use the Default, and -1
shall Disable.
NetDelay=0
;FDelay is used to configure the number of frames delay
to be added to each route request, can be any natural
number, used by Engineering only. Configure 0 to use the
default, which is 6 frames.
FDelay=0
;The configuration entries used by Router Controller En-
gine needs to be added under this section.
[RCE]
;NPMatrix is used to configure the periodicity of the
Status query to a Remote NP system, in seconds. Default
is 5 seconds, can be configured between 1 to 5, 0 shall
use the Default.
NPMatrix=0
;The configuration entries used by System Controller
Board needs to be added under this section.
[SCB]
;NoNCRelay is used to control the relay of network traf-
fic from EN1 to EN2 by NetConfig Relay Agent. To block
relay to EN2 of the system, write 'Enable', else write
'Disable'.
NoNCRelay=Disable
;WatchdogTime is used to configure the reboot wait time
of the Task Watchdog, before which it can log the diag
-
nostics. Default is 45 seconds, can be configured be-
tween 1 to 300, 0 shall use the Default.
WatchdogTime=0
;WatchdogAction is used to control the Action of the
Task Watchdog when any key task is suspended. Default is
'Disable', can be configured as 'Reboot' or 'Shutdown'.
WatchdogAction=Disable