Service manual

Encore — Installation and Service Manual 83

ENCONFIG.ini

Encore v1.8.0 SCBs employs an ENCORE.ini file to set certain system

parameters. This file consolidates parameters that were previously located

in several different system locations. This file is located in the root directory

of each SCB, is read on bootup, and can be viewed and edited using a stan

dard ascii text editor.

CAUTION Modifying the ENCORE.INI file incorrectly can adversely affect Encore system

operation. Changes to the ENCORE.ini file should only be made by qualified

personnel who fully understand the ramifications of any alterations made.

An example of ENCORE.ini text information, is shown below:

;The configuration entries used by Control Panel Server

needs to be added under this section.

[CPS]

;PBlock is used to control the Panel display updates by

redundant Control Panel Servers. To block display up

dates from subordinate write 'Enable', else write 'Dis-

able'.

PBlock=Enable

;RBlock is used to control the Router operations by re-

dundant Control Panel Servers. To block operations from

subordinate write 'Enable', else write 'Disable'.

RBlock=Enable

;MxMemory is used to configure the Maximum backlog of

system memory that can be consumed by a serial client,

in Mega Bytes. Default is 10MB, can be configured be

tween 2 to 50, 0 shall use the Default, and -1 shall

Disable.

MxMemory=0

Not Present Enabled Invalid SNTP Server System Date* Frame Count Server - SNTP

Server Not Found

Not Present Enabled Not Present System Date* Frame Count Server

Not Present Disabled Present SNTP SNTP

Not Present Disabled Not Present System Date* System Up Time

Not Present Disabled Invalid SNTP Server System Date* System Up Time - SNTP

Server Not Found

Table 16. Time and Date Sources for Logging

VITC Status

Frame Count

Status

SNTP Status

Date Source for

Logging

Time Source for

Logging