Service manual

76 Encore — Installation and Service Manual
Section 3 — Maintenance and Troubleshooting
To Replace the Fan Filter
Before starting this procedure, ensure that the fan is not operating and will
not start by disconnecting the System Controller module. You can discon
-
nect power to the System Controller module by unseating the module,
pulling it an inch or so away from the connectors on the Encore Control
frame.
See Figure 43 for the location of the fan filter.
1. Remove the Fan Filter Cover.
The cover is a snap-on, snap-off plastic grid, very little pressure is
required to remove it.
2. Remove the Fan Filter.
Either clean the Fan Filter or discard it, then use a new Fan Filter.
3. Insert the Fan Filter.
4. Replace the Fan Filter Cover.
Figure 43. System Controller Module Fan Filter
System Controller Web Pages
An Encore System Controller offers web pages to report system status and
allow some configuration changes. These web pages are accessible with a
PC configured on the same network, using NetConfig or any web browser
application.
8103_00_21
Fan Filter
Fan Filter Cover
Fan Unit