Service manual

Encore — Installation and Service Manual 73
Maintenance
To Insert System Controller Modules
1. Align the module in the appropriate frame slot.
2. Slide the module into the frame.
The fan and the LEDs will come on as soon as the pins make contact
with the backplane before the module is fully seated.
3. Seat the module by firmly pressing against the bottom edge of the
module using index fingers and thumbs.
When the module is fully seated the bevelled edge of the module will
line up with the upper card guide as shown in
Figure 40.
Figure 40. Installing the Controller Module
CAUTION Multi-pin module connectors can become misaligned and cause damage to
the backplane and interconnect. Use caution when inserting modules.
8103_00_55r0
Edge
Fully seat module by
pushing on edge
as shown
Make sure module remains
in card guide during installation.
Bevelled
corner
Controller module
Upper card
guide
Install Controller Module