Service manual

Encore — Installation and Service Manual 53

Control Panel Keycap Legends

ENC-UCP Serial RS-422 Pinouts

The ENC-UCP control panel has two parallel wired 9-pin female ports,

labeled

Data A, located on the rear of the panel. These ports can be used for

RS-422 communications. Termination is not required for short cable runs,

but may be needed for longer runs. Pinouts are shown in

Table 9.

Control Panel Keycap Legends

Control Panel keycaps suitable for Encore and Acappella hardware panels

can now be printed. A Microsoft Word template file is available that can be

populated with keycap legends using the Soft Panels application. The

resulting keycap file can be printed onto a clear sheet, cut to size, and

inserted into the hardware panel buttons.

See the separate Soft Panels Instruction Manual for more information.

Serial Cabling RS-232

COM 1 (CONSOLE) and Ports 1 to 4 RS-232

The COM 1 (CONSOLE) port on the Encore Control frame is a RS-232 serial con-

nection used for connecting to a console. The pinouts and cabling for the

port is the same on all the Encore frames. This is a non-redundant port; for

Table 9. Pinouts on ENC-UCP Control Panel

RS-422 9-Pin Female Connector

1 Ground

2 TX-

3 RX+

4 No connect

5 No connect

6 No connect

7 TX+

8 RX-

9 No connect

Pin 1Pin 5

Pin 6Pin 9

D-9 Female