Service manual

Encore — Installation and Service Manual 49
Control Panels
To correct this issue from the SMS7000 MCPU console interface:
1. FTP the files 'EraseE.mot' and 'EraseC.mot' to the MCPU. Ensure the
FTP is done in the 'bin' (binary mode). You will use “EraseE” for EPOS
panels and “EraseC” for CSOS panels.
2. From the MCPU console interface program the control panel with the
appropriate .mot file. To know which file is appropriate for a given
control panel, reset the panel and observe the boot up display of the
panel. This will show the control panel's operating system CPOS or
EPOS.
3. For a CPOS panel, such as a UCP type the following at the MCPU
console interface:
prog “EraseC.mot” cp ucp
Note Quotes and spaces must be used as shown.
• First parameter is the command 'prog'.
• The second parameter is the file name the device is to be pro-
grammed with. To use EraseC and EraseE you must know what
type of panel OS is being used for the control panel.
• The third parameter is the device type, in this case 'cp' for control
panel device types.
• The fourth parameter is the device sub-type, in this case 'ucp' for
Universal Control Panel. This will be specific to the type of control
panel being programmed.
Joystick Override
Some Encore system control panels support Joystick Override (JSO). Joy-
stick Override is commonly used to switch crosspoints from a switch
mounted at the top of the joystick (Iris and Black Level control) on a televi
-
sion camera remote control unit (RCU). This function is used by the camera
video engineer to rapidly switch the outputs from multiple cameras to his
monitoring station.
The following control panels support Joystick Override:
These control panels are equipped with a D-connectors mounted on their
rear panels, used for joystick override inputs. The camera RCU usually has
Table 5. Joystick Override Panels
Encore panels BPS, 48B, JEP-100
SMS panels P32, P48
Kalypso panels KMD, KSD