Service manual

Encore — Installation and Service Manual 39
System Cabling Example
System Cabling Example
Table 4 list the connectors on the Encore System Controller Frame. The
Gender column indicates the gender of the connector found on the frame.
The Details column contains information to assist in using the connector.
Figure 19 shows cabling for a redundant Encore Control System using a
managed switch configured with two VLANs. This example uses two
128x128 Concerto matrices, four Encore control panels, a single PC-compat
-
ible, a single managed switch, and an Encore frame with dual SCBs.
Table 4. Connectors on Encore System Controller Frame
Label
Connector
Details
Type Gender
Terminal
Block
Male Use 12 AWG (3.31 mm
2
) wire and a 3-pin terminal block connector to establish a DC power connection.
COM 1 CONSOLE RJ-45 Female RS-232 connector, use Category 5e cable, 8 conductor twisted pair.
COM 2 RJ-45 Female RS-422, RS-485 connectors, use Category 5e cable, 8 conductor twisted pair.
EN 1 and 2 RJ-45 Female Ethernet network communication interface is 10Base-T and 100Base-T compatible, use Category 5e cable, 8 con-
ductor twisted pair.
GPI IN 9 Pin D Male Future use. Cable specifications and pinouts determined by type of serial device.
GPI OUT 15 Pin D Male Future use. Cable specifications and pinouts determined by type of serial device.
GSC 1, 2, 3, and 4 BNC Female Use 75 ohm connectors, terminators, and coaxial cable. Loop-thru cabling supported.
REF OUT BNC Female Future use.
SIO 1, 2, 3, and 4 RJ-45 Female RS-232, RS-422, RS-485 connectors, use Category 5e cable, 8 conductor twisted pair.
SIO 5, 6, 7, and 8 RJ-45 Female RS-422, RS-485 connectors, use Category 5e cable, 8 conductor twisted pair.
SYNC 1 and 2 BNC Female Synchronous video references use 75 ohm connectors, terminators, and coaxial cable. Loop-thru cabling sup-
ported.
USB USB Female Future use.