Service manual

Encore — Installation and Service Manual 25
Introduction
The System Controller Frame has two slots for SCBs and two slots for
Power Supply modules, located behind the front cover/air filter. Status
indicator LEDs and a reset button are located on each SCB (
Figure 3).
Figure 3. System Controller and Power Supply Modules
Cabling and power connectors are located on the rear of the System Con-
troller Frame (Figure 4).
Figure 4. System Controller Frame Rear View
Multiple Encore System Controller Frames can be used to support large
systems and to increase throughput by dividing tasks among the control
-
lers. SCBs in the same frame can be configured to control different hard-
ware or to operate redundantly. An SCB in one frame can even operate
redundantly with an SCB in a different frame.
Power Supply Modules
Reset Buttons
System Controller Modules
8053_36r0
Slot 1
Slot 2
Slot 1
Slot 2
8053_37_r0
J31
USB
J19J20J21
J29J30
GPI
IN
GPI
OUT
J5J6J7
GSC 4 GSC 3 GSC 2 GSC 1 REF OUT SYNC 2 SYNC 1
CONSOLECONSOLE
J1J2J3J4
J16
J35
J51
C
O
M
1
C
O
M
2
J52
J53
E
N
1
E
N
2
J54
J36
J37
J38J39
SIO 45678321
J40J41J42J43J44J45J46J47J48J49J50
J17J18 J15J26J27J28
J32J33
GPI
IN
GPI
OUT
J12J13J14
GSC 4 GSC 3 GSC 2 GSC 1 REF OUT SYNC 2 SYNC 1
J8J9J10J11
J23J24J25 J22
J34
USB
PS1
PS2
COL
LNK
LNK
COL
COL LNKLNK COL
J55
+
J56
C
O
M
1
C
O
M
2
J57
J58
E
N
1
E
N
2
J59
SIO 45678321
30-60V
130W; 3.7A
Serial In/Out
Connectors (8)
Com 1
Console Port
EN1
Ethernet Port
EN2
Ethernet Port
SCB Slot 2 Connectors
DC
Power
GPI In/Out
Connectors (2)
GSC BNCs (8) Sync
BNCs (4)
Com 2
Port
SCB Slot 1 Connectors
GPI In/Out
Connectors (2)
GSC BNCs (8) Sync
BNCs (4)
Serial In/Out
Connectors (8)
Com 1
Console Port
EN1
Ethernet Port
EN2
Ethernet Port
AC
Power
Com 2
Port