Service manual

Encore — Installation and Service Manual 101
SNMP Monitoring
Matrix Controller Signal Loss Traps
A CPL Matrix Controller can now be configured to send an SNMP trap
when an input or output signal is lost on the matrix. A clear trap can be sent
when the signal is restored. The SNMP Matrix Controller web page can be
used to selectively enable or disable the sending of traps on an input-by-
input and an output-by-output basis.
SNMP Console Commands for SCB
With Encore 1.8.0 software, the Encore SCB now has five new console com-
mands available that list SNMP diagnostic information (see Table 21). This
logging option is controlled by an On/Off console command.
NP/RCL Serial Client Connects: A NP or RCL Serial client connects to Encore.
NP/RCL Ethernet Client Disconnects: A NP or RCL Ethernet client disconnects from Encore.
NP/RCL Ethernet Client Connects: A NP or RCL Ethernet client connects to Encore.
Control Panel Disconnects Control Panel disconnects from Encore.
Control Panel Connects Control Panel connects to Encore network.
Router Engine Absent Router Engine status becomes absent in Encore network
Router Engine Available Router Engine becomes available in Encore network
Table 21. SCB SNMP Logging Information
Command Information
snmpShow
a. SNMP License Status
b. SNMP Software Status
c. Trap Target IP Address.
snmpCurrentTrapListShow (Lists the current error trap that has sent from the system.)
snmpTrapDebugOn (Enables the trap details print on console.)
snmpTrapDebugOff (Disables the trap details print on console.)
snmpStatusShow
(Reports the health of SNMP software along with other information
such as how many SNMP packets are sent out from the system)
Table 20. System Controller Trap Messages - (continued)
Trap Description