Service manual

100 Encore — Installation and Service Manual
Section 3 — Maintenance and Troubleshooting
5. Send a SET request for:
gvgTtCfgEntryStatus (1.3.6.1.4.1.4947.2.1.3.3.1.4).index
where index is the value returned in the step 1 above (value 2) and value
to be 1 (Active). This will activate the newly created row. If this SET
request is successful, you are all set to receive the Traps.
If the SET request is successful you are all set to receive the Traps.
Remove a SNMP Manager
Some possible reasons for wanting to delete an SNMP Manager include:
• The SNMP manager IP Address is changed.
• You no longer wish to monitor the Encore system controller using the
SNMP manager.
• You want to delete the SNMP managers you no longer use.
Delete an SNMP Manager
From the Third Party SNMP Manager perform the following steps:
1. Scan through the gvgTtCfgIpAddress and write down the index of the
row, you want to delete.
2. Delete the above selected Row from the Trap target table by sending a
SET request for the gvgTtCfgEntryStatus
(1.3.6.1.4.1.4947.2.1.3.3.1.4).index, where index is the value returned in
Step 1 Add a New SNMP Manager on page 98, syntax is INTEGER32 and
set the value as 6 (destroy). If the SET request is successful then you
may add new SNMP Managers as described above.
SET request could be unsuccessful, if the above row is already deleted
from the Trap target table.
SNMP Trap Messages
The SNMP trap messages listed below are available for various Encore
system components.
Table 20. System Controller Trap Messages
Trap Description
Matrix Communication Error Trap CPL Matrix lost the Communication from Encore
Matrix Communication Clear Trap CPL Matrix regained the Communication to Encore
Matrix Controller Switchover Error: CPL Matrix controller is switched from Redundant to Primary.
No Mirror Panel Server: Mirrored Panel Server is not available.
Mirror Panel Server Present Mirrored Panel Server is available.
NP/RCL Serial Client Disconnects: A NP or RCL Serial client disconnects from Encore.