User`s guide

Reset to Factory Default

To restore the factory default configuration for the device, click the “Start

Resetting” button to execute.

Note:

1. All the user-defined configurations will be erased and replaced as factory default

setting.

2. We recommend users to backup the configuration status before restoring factory

default. To get more information for backup your configuration, see “Backup the

Device Configuration Status”

Character Set & UPNP & Printer

To enable the Unicode, UPNP and printer server function for the device, you have to

install the “ntx_libra.tgz” file to the device before any configuration.

To install the file,

1. Insert the included CD and click the “Browse” button.

Note: The Install Menu may auto run. Click “EXIT” to close it.

2. Select your CD-Rom drive. Double click on the “Character Set & UPNP &

Printer” folder. Select the “ntx_libra.tgz” file and click “Open” to browse the

file.

3. Click “Apply” to perform installation.

4. It takes a few seconds to perform installing, please wait upon installation.

Note:

1. The Unicode and UPNP function is activated after loading the file.

2. To use the device as a printer server, please refer to “Printer Setup” for more

instruction.