User`s guide

4. Please make sure that the HD jumper should be located for Master operation

mode.

Note: The jumper locations differ from each HD; for the correct Jumper

settings, please refer to the instruction that came with your Hard Disk.

5. Insert the IDE connector into the IDE

socket on the Hard Drive. Make sure the

pin 1 on the cable is connected to pin 1 on

the HD socket. Pin 1 is the red or pink

strip on the edge of an IDE cable. The IDE

cable connector is designed to fit the

shape of most HD connectors in one way.

6. Insert the power connector into the power

socket of your hard disk. The power cable is

designed to go in one way, please check the

shape for correct installation.

7. Secure your hard disk with the included screws in the package.