Specifications

After choosing the <Run Diagnostics on
Board> item, the screen will display like,
Node ID........: 00 e0 7d c0 00 01
Network Speed..: 100Mbps
I/O Base ......: E000H
Interrupt .....: 11
Full-Duplex ...: Disabled
Pass Count Fail
Count
A. I/O Register
B. 100Mbps Loopback
C. 10Mbps Loopback
D. Cable Connection
<Cable Connection> test reminds you that
the connection link might be fail, either the
cable is not connected or the cable link fails.
10
For the <Run Diagnostics on Network> test,
it is necessary to connect your computer with
its supporting hub or another computer. This is
a "Ping-Pong" test. This test cannot be
completed except two computers on the LAN
for sending or receiving the test packets
between computers.