User`s guide

7
Connect the Router using Wireless LAN
Figure 2. Connecting Wireless LAN Router
1. Plug in one end of the RJ45 network cable to the xDSL/Cable Modem.
2. Plug in the other end of the RJ45 network cable to the Wireless Internet Broadband Router
WAN port.
Check the installation
The control LEDs of the ENHWI-G2 802.11g Wireless Broadband Router are clearly visible
and the status of the network link can be seen instantly:
1. With the power source on, and the device is connected to the broadband cable modem, the
Power, CPU, LAN, WLAN and WAN port link LEDs of the Internet Broadband Router will
light up indicating a normal status.
2. While the WAN is link up to the ADSL/Cable modem, the WAN port’s Link/ACT LED will
light up.
3. While the LAN is link up to the computer system, the LAN port’s Link/ACT LED will light
up.