User`s manual

Serial Communication
SuperDrive 6.10 | 57
(1) PC with SuperDrive software.
(2) DB9 Male connector.
(3) RS232 serial cable for PC/Drive connection.
(4) Drive.
(5) RJ11 connector.
Drive
Board
Connector
Jumper
CFW-05
CEC5/MEC5
XC7
XJ3=1-2
CFW-07
CEC8
XC3
CFW-08
MCW-01(COS1)
XC8
CFW-09
RS232 Serial Interface
XC7
SSW-03
CCS1
XC2
SSW-04
CCS4
X3
SSW-05
CCS50, CCS51
Serial Port RS232
SCA-04
CCA-1
X4
SCA-05
CCA-5
X4
CTW-04
CCW4
XC3
MVW-01
MVC2
XC7
The DB9 connector should be connected to one on serial ports of the microcomputer. Use one the 16 serial
ports (COM1 to COM16), since this information will be requested later by the SuperDrive during operation.
RS232 PC/DRIVE SERIAL CABLE
Figure below shows the cable parts for point-to-point RS232 connection. Only pins 2, 3 and 5 of the DB9
female connector are used.
Length: 3 meters.
Maximum cable length: 10 meters.
DB9/DB25 ADAPTER