User`s manual

Menus
SuperDrive 6.10 | 46
Read the Project - it reads each parameter stored in the project and loads them in the suitable field.
Read the Drive - it reads each parameter from the drive and loads them in the suitable field. The read
parameters are not stored in the project. They are only displayed.
See orientative diagram - a new window is opened, where the diagram is orientative and corresponds to a
standard factory configuration. It does not correspond to the user selected configuration.
4.5.4 Multispeed with Commands via Digital Inputs
ACCESS
Menu: Macros + Multispeed with Commands via Digital Inputs
Shortcut Key: -
FUNCTION
It allows defining the macro for the CFW-09 drive.
The macro parameters can be saved in file. The macro can also be printed.
DESCRIPTION
The user can operate the drive with up to 8 fixed predefined speed that can be selected via digital inputs.
The user can visualize the function of each pin of the XC1/XC1A terminal according to the selections. Next
each selected item you can see the content of each parameter which will be sent to the drive when the
macro will be sent. The user must also select the number of speeds and then fill-in the value of each speed
P124 ... P131.
Selections
Local/Remote Selection:
· Always local
· Alaways remote
Direction of Rotation:
· CW
· CWW
· Reversal via DI2
Start/Stop Command via DI:
· Local (displayed when local/remote = always Local has been selected)
or
· Remote (displayed when local/remote = always Remote has been selected)
Number of Speeds:
· 2 speeds
P124 - Reference 1 Multispeed
P125 - Reference 2 Multispeed
or
· 4 speeds
P124 - Reference 1 Multispeed
P125 - Reference 2 Multispeed
P126 - Reference 3 Multispeed