User`s manual

Menus
SuperDrive 6.10 | 45
DESCRIPTION
User can command the drive from an only command origin which commands for speed reference, run/stop
and direction of rotation should be defined previously
The user can visualize the function of each pin of the XC1/XC1A terminal according to the selections. Next
each selected item you can see the content of each parameter which will be sent to the drive when the
macro will be sent.
When Multipeed will be selected in the Speed Reference , the user must fill-in the value of P124 ... P131.
Selections
Options for the Speed Reference:
· Analog Signal from 0 to 10 Vcc - AI1
· Analog Signal from 0 to 10 Vcc - AI2
· Analog Signal from 0 to 20 mA - AI1
· Analog Signal from 0 to 20 mA - AI2
· Analog Signal from 4 to 20 mA - AI1
· Analog Signal from 4 to 20 mA - AI2
· Potentiometer 5 kOhms 1 or 10 turns - AI1
· Potentiometer 5 kOhms 1 or 10 turns - AI2
· Electronic Potentiometer - DI3/DI4
· Electronic Potentiometer - DI5/DI6
· Multispeed
· Via HMI keypad
· Via serial
Options for Run/Stop Commands:
· Via digital input with ramp enable
· Via digital input with general enable - DI1
· Via digital input with general enable - DI3
· Via digital input with general enable - DI4
· Via digital input with general enable - DI5
· Via digital input with general enable - DI6
· Via digital input with ramp and general enable - Disable by Ramp DI1 - General Enable DI3
· Via digital input with ramp and general enable - Disable by Ramp DI1 - General Enable DI4
· Via digital input with ramp and general enable - Disable by Ramp DI1 - General Enable DI5
· Via digital input with ramp and general enable - Disable by Ramp DI1 - General Enable DI6
· Via HMI Keypad
· Via serial
Options for Direction of Rotation:
· Only one Direction of rotation - CW
· Only one Direction of rotation - CCW
· CW/CWW via digital input.
· Via HMI Keypad - CW
· Via HMI Keypad - CCW
· Via serial - CW
· Via serial - CCW
File Name - file name to save the macro.
Save - saves the macro in file.
Search - it allows selecting a macro file.
Print - it prints the macro.
Send - it sends the macro to the drive.