User`s manual

Menus
SuperDrive 6.10 | 41
window shows the drives their characteristics.
Manual Selection
The manual selection is used when no drive is connected to the SuperDrive and is used only to create and
offline configuration.
The user can insert 1 drive in RS232 and up to 30 drives in RS485.
For each drive you must define at minimum the address, type and firmware version. The definition of the
rated voltage, rated current and tag are optional.
The drives have the following characteristics:
CFW-05, CFW-07, CFW-09, SSW-03, SSW-04, MVW-01:
Address, type, firmware version, rated voltage, rated current.
CFW-08, SCA-04, SCA-05, SSW-05:
Address, type, firmware version, rated current, rated current. (there is no rated voltage).
In manual selection, the firmware version defined by the user must be the same as that in the drive that will
be connected to the PC.
4.4.13 Communication Settings
ACCESS
Menu: Online + Communication Settings
Shortcut Key: -
FUNCTION
Configures Serial Port.
DESCRIPTION
Serial number of the port: 1...16 (COM1...COM16). It is the number of COM that will realize the
communication between drive and SuperDrive.
Number of trials to transmit a telegram through serial port when an error is found: 1...10. This is the
number of trials to send a telegram when the drive is not answering, i. e., the SuperDrive will send the
telegram how often the number of trials will be.
Time-out to receive a telegram (ms): it is the time that SuperDrive waits to consider an error.
Modem delay time-out (ms): extra time considered during the serial communication when a modem is
used.
It tests the drive type and the firmware version before the telegram is sent via serial port: enabled or not.
SuperDrive checks if the connected drive is of the same type and firmware version of the project before it
starts the serial communication.
No other application can use this serial port simultaneously with the SuperDrive.