User`s manual

Menus
SuperDrive 6.10 | 36
· Computer operational system is slow; too many programs running at the same time; number of
parameters and samples being acquired.
· The timer that controls the sampling rate restarts the count when the processing routine ends; therefore,
all above delays are added to the acquisition time.
4.4.8 View Chart
ACCESS
Menu: Online + View Chart
Shortcut Key: -
FUNCTION
It permits to view the chart with up to 4 parameter that were acquired (Acquire Parameter function).
DESCRIPTION
User must select the name of the chart file (.cht extension).
The chart is displayed in the window and it also indicates some information about the chart.
This information is the same that has been entered by the user in the window "Acquire Parameter", besides
the start data, start hour, end data and end hour.
The following information will be available:
· the scale of each parameter can be changed in the range from 1...32767.
· function of each parameter.
· chart type selection: bar 3D, bar 2D, line 3D, line 2D, area 3D, area 2D, step 3D, step 2D.
· the user can enable/disable the grid , the marker or the line.
· printing of the chart with all information contained in the window.
· export graph data to Microsoft Excel.
· definition of the number of visible points displayed on the graph (25 ... 2500).
4.4.9 Online Graph
ACCESS
Menu: Online + Online Graph
Shortcut Key: -
FUNCTION
This function allows monitoring (acquiring) up to 4 signals (parameters/variables) and visualizing these
signals in a graph simultaneously.
DESCRIPTION
Signal Selection
The user shall select the channels combo boxes to be used for the data acquisition, the drive address and
the signal (parameter/variable) to be monitored on the correspondent lists. By choosing the drive address,
the drive model and the firmware version will be displayed, and the available signals will be loaded into the