User`s manual

Menus
SuperDrive 6.10 | 33
&V
shows the current configuration and the saved profile.
To implement these commands correctly, check the modem manual or contact the ATMC Technical
Support.
Jumpers of the Modem MV34:
S1 = 2-3
S2 = -
S3 = 2-3
Encore Electronics Inc.
http://www.encore-usa.com/product.php?id=30
Model ENF656-EV-CIPR external modem.
To display the commands, use the commands "ATE1".
E1 = Eco enabled, ecoa commands to the computer to display what is entered via keypad.
To operate the auto-answer, the manufacturer suggests to apply following commands:
"AT&F&D0X3&K0S2=128S0=2".
AT
informs the modem that an AT command is coming.
&F
loads factory setting.
&D0
ignores DTR signal.
&X3
enables dialing without tone recognition.
&K0
disables the local flow control.
&S2=128
ignores escape sequence.
&S0=2
answers after 2nd ringing (auto answer).
The user must save the configuration in NVRAM by using "AT&W&W1".
&W
saves active profile in profile 0.
&W1
saves active profile in profile 1.
To display what has being saved, enter "AT&V".
&V
shows the current configuration and the saved profile.
To implement these commands correctly, check the modem manual or contact the ATMC Technical
Support.
How to install a standard modem on Windows
· Go to the Start Menu/ Configuration / Control Panel -> Modem and telephone options -> Modems.
· Press the button Add.
· Select: "Do not detect the modem. It will be selected from a list" and press Next.
· Select "(standard Modem types)" and "33600 bps standard Modem" and press Next. Obs.: in the model
section the model must be selected according to modem manufacturer specification.
· Select the serial port where the modem will be connected and press Next. Obs.: This information will be
necessary to configure the serial communication of the SuperDrive when on the "Online" menu the
"Monitoring using modem" option is used.
· Press Finish.
· The modem has been created and it appears on the Modem and telephone Options
· It is possible to visualize the properties of the modem by clicking on the Properties button.
4.4.7 Acquire Parameter
ACCESS
Menu: Online + Acquire Parameter