User`s manual

Menus
SuperDrive 6.10 | 28
Enter and click on OK.
Commands
Show/Hide - This command shows or hides the secondary parameter lines on the grid.
Ok - when this command is give, you exit the window.
Help - this command opens a Help window.
4.4.5 Monitor Using Keypad
ACCESS
Menu: Online + Monitor Using Keypad
Shortcut Key: -
FUNCTION
This function allows to show/change the drive parameter in a similar way as the drive keypad.
DESCRIPTION
CFW and MVW Line
The keypad (HMI) is a simple interface that allows the inverter operation/programming.
This interface allows permits following functions:
· indication of the operation status, as well as the display of the main variables.
· fault display.
· visualization and changing of the settable parameters.
· operation: enable, disable, reversal, jog, commutation: local/remote, incrementing/decrementing the
parameter number, general enable, general disable, serial reference.
· virtual keypad - local: the key Enable allows that all commands can be executed via serial interface in
local status, the key Disable allows that all commands can be executed via serial interface (HMI) in local
status.
· virtual key - remote: the key Enable allows that all commands can be executed via serial interface in
remote status, the key Disable allows that all commands can be executed via serial interface (HMI) in
remote status.
Line SSW
The keypad (HMI) is a simple interface that allows the soft-starter operation/programming.
This interface allows permits following functions:
· indication of the operation status, as well as the display of the main variables.
· fault display.
· visualization and changing of the settable parameters.
· operation: enable, disable, reversal, jog, incrementing/decrementing the parameter number, general
enable, general disable.
· Motor status: acceleration. Current limiting, rated voltage, energy saving, deceleration, braking, reversal
and power supply.
Line SCA
The keypad (HMI) is a simple interface that allows the servodrive operation/programming.
This interface allows permits following functions:
· indication of the operation status, as well as the display of the main variables.