User`s manual

ENDSS-R4D8
83
NOTE Make sure to properly configure the Pan/Tilt/Zoom Setup. You can
access this menu by going to the Main Menu then Hardware Menu
and then clicking on Keyboard/PTZ Setup. Without activating the PTZ
feature, the PTZ Control icon will not appear on the Control Bar.
PTZ Control Menu
The PTZ Control Menu is your command center for manipulating and setting your
pan/tilt/zoom-enabled camera.
Icon
Name
Operation
-
Preset Buttons
These allow you to direct your camera towards a
predefined location. Move your mouse on top of the
number and when it starts to blink, the following
operations can be performed:
/ Left-Button Mouse Click : Calls the preset and the
camera directs to that stored location
/ Right-Button Mouse Click : Programs a preset
position
/ Right-Button Hold for 2 seconds: Clears the stored
preset position
Buttons with stored presets are displayed in a vivid
green color.
Cruise Start
Left-click this icon to begin linear and lateral panning.
Cruise Stop
This icon appears after Cruise has been activated. Left-
click this icon to stop linear and lateral panning.
Auto Pan Start
Left-click this icon to begin horizontal panning.
Auto Pan Stop
This icon appears after Auto Pan has been activated.
Left-click this icon to stop horizontal panning.
Setup Left Limit
Direct your camera to your desired location and left-click
on this icon to specify the leftmost limit for panning.
Setup Right Limit
Direct your camera to your desired location and left-click
on this icon to specify the rightmost limit for panning.
Auto Iris
Left-click on this icon to automatically set the optimal
amount of light that enters the lens