User`s manual

ENDSS-R4D8
93
Setup DVR IP Address
When you find a usable IP address, go back to DVR menu: “Network Setup” to enter IP
address.
IP ADDRESS: Enter the DVR‟s address [192.168.011.188]
GATEWAY: Enter Router IP Address[192.168.011.001]
Subnet MASK: 255.255.255.0
NOTE You must plan on the network structure if the MIS or Network
Administrator manages the network.
You should consult with the MIS or Network Administrator for the IP
address segment and port-forwarding rule for the DVR network setup.
7.2 DynDNS Service Overview
For DVR you can only set a static IP address. It does not support the dynamic IP. If
you have to or prefer to use dynamic IP, then it is recommended to use a DYNDNS
service.
DYNDNS is a service the maps internet domain names to IP address and works with
dynamic IP address (assigned by ISP server).
Remark: A router is needed as the interface between PC and DVR when DVR is under
internal network environment.
7.2.1 Register to the DynDNS Services
NOTE The following screens are captured from the DYNDS web site at time
of this writing. Changes might occur by the time you check their site.
NOTE As of this writing, the DYNDS service is free. Contact the DYNDS
company if the service is still free to make sure, before creating an
account with them.
There are three suggestions for DYNDNS service:
www.no-ip.com, www.changeip.com and www.dyndns.com
The following will use DYNDNS website: http://www.dyndns.com as example.
If you have no account, create one when you access DynDNS (DYNDNS service)
website.