Installation manual

E9 IN REV. A
21
1. Press button once on the transmitter to start the vehicle.
2. If everything goes well:
a. Press
button once on the transmitter to stop engine running. You have been completed this programming
successfully.
b. Press
button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking light flashes
for confirmation.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press
once on the transmitter to stop engine running or press brake pedal.
Press
button on the transmitter to set proper “Check Level ” to Low position. [1] LED flash, [1 chirp will
confirm this setting
b. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, crank stopped before starting):
a. Press
button once on the transmitter to stop engine running.
Press
button on the transmitter to set proper “ Check Level ” to Hi position. [2] LED flash, [2 chirps will
confirm this setting
Repeat steps 1 – 4 if necessary.
VOLTAGE CHECKING TYPE
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. Default setting
2. Push the Valet switch 7 times and hold it on the 7
th
push until a long chirp is hearing then release the valet
switch.
3. Press the transmitter and buttons at the same time to set the “Voltage Checking Type”. [1] LED flashes, [1]
chirp to confirm this setting
Once you complete step 3, you can adjust and test “Start Timer” as below:
START CRANK TIME PROGRAMMING: (TEST and
ADJUST)
1. Press button once on the transmitter to start the vehicle.
2. If everything goes well:
Wait for 15 seconds:
a. If the engine still running.
I. Press button once on the transmitter to stop engine running. You have been completed this programming
successfully.
II. Press
button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking light
flashes for confirmation.
b. If the engine shuts down after the vehicle has been started.
I. Press
button once on the transmitter to stop engine running.
II. Press
button on the transmitter to set “Check Level” to LOW position. [1] LED flash, [1] chirp to confirm
this setting
III. Repeat steps 1 – 2.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press
button once on the transmitter to stop engine running.
b. Press
button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm entry.
(Decrease “Start Timer” is necessary.)
c. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not started, crank time stopped):
a. Press
button once on the transmitter to stop engine running.
b. Press
button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm entry.
(Increase “Start Timer ” is necessary.)
c. Repeat steps 1 – 4.
Timer Checking Type
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 7 times and hold it on the 7
th
push until a long chirp is hearing then release the valet
switch.