Installation manual

E3 IN REV. A
4
Main Power Connector
RED / WHITE: PARKING LIGHT RELAY INPUT
WHITE: PARKING LIGHT OUTPUT
BLACK : MAIN SYSTEMS GROUND
BROWN : POSITIVE SIREN OUTPUT
RED : FUSED 12 VOLT (+) BATTERY POWER
3 PIN, DOOR LOCK CONNECTOR
1. Blue Wire
3. Green Wire
( - ) Lock Pulse
( + ) Unlock Pulse
( - ) Unlock Pulse
(
+
)
Lock Pulse
8 - Pin Accessory Connector
- GRAY WIRE / CHANNEL 3 NEGATIVE TRUNK OUTPUT
- ORANGE :STARTER INTERRUPT O/P RELAY REQUIRED
- YELLOW / IGNITION INPUT (+)
- GREEN / (-) DOOR TRIGGER INPUT
- BLUE / (-) INSTANT TRIGGER INPUT ( HOOD, TRUNK)
- VIOLET / (+) DOOR TRIGGER INPUT
- WHITE / DOME LIGHT (OR CH#4 O/P) RELAY REQUIRED
- BROWN/ WHITE / (-) HORN OUTPUT.
WIRING
Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Be sure to tape wires
that pass through holes on the firewall to prevent fraying.
CAUTION: Do not connect the wire harness to the control module until all wiring to vehicle is complete.
2 PIN WHITE CONNECTOR (THE LED STATUS INDICATOR):
The led indicator status should be mounted in a highly visible area such as top of the dashboard, on top