Owner's manual
ENCORE
5
Follow the installation instructions printed on
the filter. Use only a high quality 20W50
rated engine oil. NOTE: Refer to the engine
manual for engine lubrication recommen-
dations.
OIL AND FILTER for 42K17Z ;
48K19Z ; 52K21Z.
Change the hydraulic system filter at 250
hours. The hydraulic filter is located on the
hydraulic tank. Note: Clean filter area before
remounting to prevent contampuation.
Change hydraulic oil in the reservoir yearly.
Use only a high quality Mobile 1 - 15w50
rated oil. NOTE: Refer to the engine
manual for engine lubrication recommen-
dations.
TIRE PRESSURE
This vehicle has been designed to achieve
maximum operator comfort and ride. This
cannot be achieved without proper tire pres-
sure. A low pressure gauge is required to
check the front tires.
Front Tires - 14 PSI
Rear Tires - 20 PSI
BATTERY
For maintenance of acid filled battery the
electrolyte level above plates in each cell by
adding distilled water as necessary. The best
time to add water is just prior to operating the
mower so water will mix with the solution. Do
NOT over fill battery: Electrolyte solution is
NOTES:
The Encore Rider is driven and steered by
the rear wheels.
REAR TIRE CIRCUMFERENCE DIRECTLY
EFFECTS THE TRACKING OF THE
MACHINE.
If the machine will not drive in a straight line,
check air pressure and adjust accordingly.
CAUTION:
When servicing the battery or any other part
of the electrical system, or if the battery must
be removed for any reason, always, discon-
nect negative (ground) cable FIRST and re-
connect it LAST to avoid possibility of electri-
cal shorts.
At temperatures below 32° F (0° C), full charge
state must be maintained to prevent cell elec-
trolyte from freezing and causing permanent
battery damage.
CAUTION:
Batteries produce flammable hydrogen gas.
Avoid creating sparks and open flames and
do not smoke when working near batteries.
Battery electrolyte solution is poisonous and
can be injurious to eyes, skin and clothing.
IN THE EVENT OF AN ACCIDENT: Flush
affected area immediately with a solution of
one part baking soda to four parts water. If
baking soda is not readily available, flush
affected area with water. Notify physician
immediately.
corrosive and over filling can cause damage
to surrounding metal parts. Battery should be
maintained at 1.265 gravity charge. When
replacing battery after servicing, take care to
reconnect cables exactly the way they were
before removing the battery.
The gel-cell battery is maintenance free.
For longest service life, battery should be
kept clean by wiping it off with a paper towel.
Any corrosion around battery should be
removed by applying a solution of one part
baking soda to four parts water. A light coat-
ing of grease or petroleum jelly may be ap-
plied to all exposed terminal surfaces to
prevent corrosion.