User guide

ConÞguration 3-39
3
Table 3-14 External Alarm ConÞguration Parameters
Parameter Setting Description
External Alarm
Input Indication
Enabled or Disabled DefaultÑDisabled. EnabledÑEnables the SoloT1 to
receive alarms from an external source (such as a
door opening or a burglar alarm). You must have a
device attached to the DB-9 connector (labeled
ALARM IN/OUT) on the back panel. You can have
more than one connection on the DB-9 connector.
External Alarm
Input Contacts
Normally Open,
Normally Closed
DefaultÑNormally Open. Select Normally Open or
Normally Closed depending on how the mechanism
from the external source (such as a door opening or
a burglar alarm) is set.
External Alarm
Input Message
20 characters
maximum
Enter an alarm message (20 maximum) that will
appear when an external alarm occurs. External
Alarm Input Indication must be enabled and
External Alarm Input Contacts must be properly set.
External Alarm
Output
Indication
Enabled or Disabled DefaultÑDisabled. Set to Enabled to enable a
device, connected to the ALARM OUT connector
(such as a bell or light)
External Alarm
Output Contacts
DefaultÑNormally
Open.
(View only) Normally Open ÑAlways